diff -r 45ec3ccb276f -r 11b306ba3468 content/hp8662a.rst
--- a/content/hp8662a.rst	Wed Apr 11 23:17:04 2018 +0200
+++ b/content/hp8662a.rst	Wed Apr 11 23:11:52 2018 +0200
@@ -42,6 +42,7 @@
 before even attempting to fix the PSU.
 
 .. image:: {filename}images/hp8662a/dirty_hp.jpg
+   :class: image-process-large-photo
 
 
 And I must say that if most of the unit is very easy to service due to the
@@ -51,14 +52,18 @@
 so very tedious.
 
 .. image:: {filename}images/hp8662a/top_before_2.jpg
+   :class: image-process-large-photo
 
 .. image:: {filename}images/hp8662a/bottom_before.jpg
+   :class: image-process-large-photo
 
 .. image:: {filename}images/hp8662a/front_after.jpg
+   :class: image-process-large-photo
 
 Also, there are hundreds of screws in this unit! it's insane.
 
 .. image:: {filename}images/hp8662a/top_after.jpg
+   :class: image-process-large-photo
 
 Whatever, I finally got to a point I could clean most of the parts of the unit,
 so I started to reassemble it. Unfortunately, I did not took enough pictures
@@ -66,12 +71,14 @@
 like an HP 8662A...
 
 .. image:: {filename}images/hp8662a/reassembling_2.jpg
+   :class: image-process-large-photo
 
 Once I had the structure of the generator back togother, with the back plane in
 place but no other board nor module plugged in, I started to take care of the
 PSU.
 
 .. image:: {filename}images/hp8662a/reassembling_1.jpg
+   :class: image-process-large-photo
 
 The PSU
 =======
@@ -87,6 +94,7 @@
   the mani switch on the front panel only activate the switching.
 
 .. image:: {filename}images/hp8662a/PSU_simplified_schematic.jpeg
+   :class: image-process-large-photo
 
 The 4 boards the PSU is made of are:
 
@@ -106,6 +114,7 @@
   regulation being made on the 5.2V rail, which is not regulated by A7A1.
 
 .. image:: {filename}images/hp8662a/PSU_block_diagram.jpeg
+   :class: image-process-large-photo
 
 So I gave a close look at thes boards, beginning by the main board, the I found
 the culprit for the smoke: the input protection thermistor. Strangely, it still
@@ -138,6 +147,7 @@
 the inverter board were very low. Somethin was wrong.
 
 .. image:: {filename}images/hp8662a/PSU_inverter_schematic.jpeg
+   :class: image-process-large-photo
 
 Looking at the schematics and the boards, I did find several failure points:
 
@@ -160,6 +170,7 @@
   skookum but does the job for a few cents.
 
 .. image:: {filename}images/hp8662a/broken_choke.jpg
+   :class: image-process-large-photo
 
 After these fixes, I reassembled the PSU and tried again: the result was quite
 promising, but not a complete success: the PSU seemed to start, but very