Mercurial > pygpibtoolkit / changeset

--- a/pygpibtoolkit/prologix.py	Mon Feb 25 23:19:42 2008 +0100
+++ b/pygpibtoolkit/prologix.py	Mon Feb 25 23:21:08 2008 +0100
@@ -24,11 +24,17 @@
         """
         self._cnx = serial.Serial(port=device, baudrate=baudrate, timeout=timeout)
         self._timeout = timeout
-        
-        self.set_mode(mode)
-        self.set_address(address)
-        self._set_cmd('auto', 0)
-        
+
+        try:
+            res = self._cnx.readlines()
+            if res: # empty evetual read buffer
+                print "there where pending stuffs in buffer", repr(res)
+            self.set_mode(mode)
+            self.set_address(address)
+            self._set_cmd('auto', 0)
+        except Exception, e:
+            print "Humm, something went wrong", e
+            
     def set_address(self, address, check=True):
         """
         Set the address of the GPIB device:
@@ -54,6 +60,8 @@
         """
         self._set_cmd('mode', mode)
         self._mode = mode
+        if self._mode:
+            self._cnx.write('++ifc\r')
 
     def set_controller(self):
         """
@@ -89,7 +97,7 @@
         self._cnx.write('++read eoi\r') # idem
         ret = ""
         i = 0
-        while not ret.endswith('\r\n') and i<2:
+        while not ret.endswith('\r\n') and i<3:
             ret += ''.join(self._cnx.readlines())
             time.sleep(self._timeout) # required?
             i += 1
@@ -148,3 +156,15 @@
             rval = self._read().strip()
             if not rval.isdigit() or int(rval) != value:
                 raise ConnectionError("Can't set GPIB %s to %s [ret=%s]"%(cmd, value, repr(rval)))
+
+    def reset(self):
+        """
+        Perform a reset of the USB device
+        
+        """
+        print "Resetting GPIB controller"
+        self._cnx.write('++rst\r')
+        print "Must wait for 5 seconds"
+        time.sleep(5)
+        
+